Lincoln Electric IM795 - Manual (Page 24)

C-2 C-2 ACCESSORIES
MIG (GMAW)
CONVERSION
Several changes are needed to convert the unit for
operation with the MIG (GMAW) process. The follow-
ing conversions should be reviewed before welding
with (GMAW):
1. Change the output polarity to DC(+). See “Work
Cable Installation” in Installation section for details.
2. Install proper drive roll for the wire size selected.
See “Changing Drive Roll” in Maintenance section
for details.
3. Install the proper gun liner and tip for the wire size
selected. See “Component Replacement” in
Maintenance section for details.
4. Remove gasless nozzle (if installed) and install gas
nozzle.
5. Load wire into machine and thread into gun and
cable per “Welding Wire Loading” section.
REPLACEMENT PARTS
Complete Gun and Cable Assembly (Code 10983)
L11951
Complete Gun and Cable Assembly (Code 10982)
L8311-5
SP 170-I