Lowrance electronic LMF-400 - Manual (Page 25)

23
If you have one tank it will be shown as Fuel Tank. Other tanks will be
displayed as Blackwater Tank, Freshwater Tank, Oil Tank, Live Well
Tank and Waste Water Tank. If you have more than one of the tank
types above, it will be displayed as Blk Wtr 1, 2, 3, Live Well 1, 2, 3, etc.
If the tank or tanks have not been configured, they will be listed as
Unfcg F Level.
To unconfigure Fluid Level:
1. Choose a configured Fluid Level from the Bus Devices list and press
ENTER .
2. Highlight U
NCONFIGURE
and press ENTER , which will launch the
following message: Press Enter to Unconfigure Device.
3. Press
ENTER and you will be returned to the Bus Devices list where
you now will see UnCfg F Level on the devices list.
To Configure Fluid Level:
1. Select
U
NFCG
F L
EVEL
from the Bus Devices list and press ENTER ,
which will launch the following message: Press ENTER to configure
Fluid Level Sensor.
2. Press
ENTER and a menu will be called up with these configuration
options: Fuel, Fresh Water, Waste Water, Live Well, Oil and Black
Water. You can have up to three tanks for each category.
NOTE:
The gauge must be set to Fuel Level for the Fuel Remaining Source
to display fuel level sensor information properly. For more
information on the topic, see Fuel Remaining source under Fuel
Setup in Section 5, Advanced Operation.
To configure Fuel:
1. Highlight F UEL
from the list of configuration options and press ENTER .
The number of options on the menu will vary with the number of tanks
you selected during Boat Setup. See Boat Setup on the first page of
Section 3: Operations.
If you have three tanks, a menu will appear with these options: Port
Tank, Cen (Center) Tank and
Stbd (Starboard) Tank.
2. Highlight one of the three tank options and press ENTER , which will
take you back to the Bus Devices list. If you have more than one tank,
one of the following will now be on the list: Fuel Tank (P), Fuel Tank
(C), Fuel Tank (S). If you have one tank, Fuel Tank will be on the list.
To configure Fresh Water:
1. Choose F
RESH
W
ATER
from the list of configuration options and press
ENTER . A window will appear prompting you to input the tank number.
2. Enter the tank number (1, 2 or 3) and press ENTER . That will launch
a tank size window.