Band switch, Installation – Legacy Car Audio LCDCS92 User Manual
Page 6
Page. 6
P / N : 570-111802-03
BAND SWITCH
Use small screw driver to select either in Europe or in USA band stepping by moving the
switch left or right.
INSTALLATION
1. Install brackets and screws removed from your old radio (not provided with this radio).
2. Slide radio and frame into dash opening.
3. Trim ring has precut grooves on the back of it. The size of the trim ring can be reduced
(mad e smaller) for different types of installations. Hold the trim ring firmly in one hand, and
using a pair of pliers, grasp the trim ring above the score line (groove) and bend gently
back and forth a couple of times. Then, the piece should break away.
4. Install dash panel.
5. Install faceplate by fitting right edge into position then pushing left edge closed.
P / N : 570-111802-03