Lexmark 5770 - Manual (Page 66)

Troubleshooting
60
Troubleshooting
General print quality
problems Try one (or more) of the following suggestions to
correct this problem:
• A print cartridge may be out of ink or low on
ink. If the Ink Low message has appeared on
your screen, install a new print cartridge. See
“Installing or replacing print cartridges” on
page 22. To view the ink level, check the ink
level graphic shown on the Cartridges Tab or
the Status Tab of the Control Program.
• Change the Print Quality setting to something
other than Quick Print 600.
• Clean the print cartridge nozzles. See
“Cleaning the print nozzles” on page 29.
• Make sure the print cartridges are installed
correctly. See “Installing or replacing print
cartridges” on page 22.
• Make sure you are using the correct type of
paper.
• Adjust the Brightness and Contrast.
Improperly formed
or misaligned
characters Clean the print cartridge nozzles. See “Cleaning
the print nozzles” on page 29.
Poor print quality at
left, right, or bottom
edge of page Like other printers, your printer cannot print in the
extreme left, right, or bottom edges of a page. To
avoid poor print quality at the edges of the page,
we recommend using these minimum margin
settings:
Left and Right Margins
Left and right margin settings must be at least 6.35
mm (0.25 in.) each for all paper sizes except A4.
For A4 size paper, left and right margin settings
must be at least 3.37 mm (0.133 in.) each.
Top and Bottom Margins
The top margin must be set to at least 1.7 mm
(0.067 in.).
The bottom margin setting for all paper sizes must
be 12.7 mm (0.5 in.) for monochrome printing and
19.5 mm (0.75 in.) for color printing.
Problems Solutions
5700.book : trouble.fm Page 60 Thursday, July 16, 1998 3:49 PM