Lenoxx Electronics PDV-705 - Manual (Page 9)

IB-PDV705-WM-E-010506
REMOTE CONTROL OPERATION
8
NOTE:
• Point the remote control unit from less than 20 feet (6 m) from the remote sensor and within
about 60
o of the front of the unit.
• Batteries should be changed by an adult for safety.
• Reversing polarities will damage the batteries and possibly your REMOTE. Be sure to follow
polarity ( + and –) as indicated.
•
Do not mix different types batteries together (Alkaline, Carbon-Zinc, Nickel-Cadmium etc.),
or old batteries with new ones.
•
When the batteries have become discharged, they must be disposed of in a safe manner that
complies with all applicable laws.
• When the batteries becomes weak, the operating distance of the remote control will be
greatly reduced and you will need to replace the batteries.
• When the remote control is not to be used for a long time (2 months or more), remove the
batteries to avoid possible damage that may be caused by batteries leakage.
• Avoid keeping the remote control in extremely hot or humid locations.
• Do not point bright lights at the remote control sensor (like laser pointers).
• Do not place objects between the remote control unit and the remote control sensor.
• Do not use this remote control while using the remote control unit of any other equipment at
the same time, the signals may mix.
Working conditions and precautions for the rechargeable battery
•
New batteries should be fully charged before initial use.
•
Battery should be changed by an adult for safety.
•
Battery should only be used and charged when temperatures are between 32 -100 O F.
•
Never put the battery in fire or water.
•
Do not expose the battery to high temperatures or store in hot, sunny places.
•
Do not short the battery terminals.
•
Do not open the battery.
•
When the battery is weak, the ON/STANDBY indicator will flash and the Low Power icon
“
” will appear on the LCD screen and then the power automatically turns off. If this
occurs, please use the AC adaptor to recharge the battery or play the set on AC power.
1. Push the door tab to open the battery door. 2. Insert 2 size “AAA” alkaline batteries
(included) into the battery compartment
according to the + and – markings
inside the battery compartment, then
replace to close the battery door.
IB-PDV705-WM-E-010506.pmd 4/3/2006, 9:24 AM 9