La Crosse Technology WS-9730U-IT - Manual (Page 4)

4
DISPLAY OF OUTDOOR TEMPERATURE READING:
The outdoor temperature is measured and displayed on the first section of the LCD.
DISPLAY OF OUTDOOR MAXIMUM AND MINIMUM TEMPERATURE RECORDS:
1. Press the OUT button once, the min outdoor temperature will be displayed.
2.
By pressing OUT button once more, the max outdoor temperature will be shown.
3. Press one more OUT button to advance to normal display.
RESETTING THE OUTDOOR MAXIMUM/ MINIMUM TEMPERATURE RECORDS
Note: The outdoor minimum and maximum records are to be reset at the same time
1.
In normal display mode, press the OUT key once. The min outdoor temperature will be
displayed.
2. Then press and hold the OUT key for about 3 seconds, this will reset the outdoor minimum and
maximum temperatures to the current value.
DISPLAY OF INDOOR MAXIMUM AND MINIMUM TEMPERATURE RECORDS:
1. In normal display mode, press the IN button once. The min indoor temperature will be shown in
the LCD.
2. Then press the IN button one more time, the max indoor temperature will be shown.:
3.
Press one more time the IN button to go back to the normal display.
RESETTING THE INDOOR MAXIMUM/ MINIMUM RECORDS
Note: The indoor minimum and maximum records are to be reset at the same time
1.
In normal display mode, press the IN key once. The min indoor temperature will be displayed.
2. Then press and hold the IN key for about 3 seconds, this will reset the indoor minimum and
maximum temperatures to the current value.
915 MHz RECEPTION
The Weather station should receive the temperature data within 5 minutes after set-up. If the
temperature data is not received 5 minutes after setting up (not successfully continuously, the outdoor
display shows “- - -” ), please check the following points:
1.
The distance of the Weather station or sensor should be at least 1.5 to 2 meters away from any
interfering sources such as computer monitors or TV sets.
2. Avoid positioning the Weather station onto or in the immediate proximity of metal window
frames.
3. Using other electrical products such as headphones or speakers operating on the same signal
frequency (915MHz) may prevent correct signal transmission and reception.
4. Neighbours using electrical devices operating on the 915MHz signal frequency can also cause
interference.
Note:
When the 915MHz signal is received correctly, do not re-open the battery cover of either the sensor or
Weather station, as the batteries may spring free from the contacts and force a false reset. Should this
happen accidentally then reset all units (see Setting up above) otherwise transmission problems may
occur.
The transmission range is about 100 m from the sensor to the Weather station (in open space).
However, this depends on the surrounding environment and interference levels. If no reception is
possible despite the observation of these factors, all system units have to be reset (see Setting up).
MOUNTING
POSITIONING THE WEATHER STATION:
The Weather Station may be hung onto wall easily or free standing.
To wall mount
Choose a sheltered place. Avoid direct rain and sunshine.
Before wall mounting, please check that the outdoor temperature values can be received from the
desired locations.
1. Fix a screw (not supplied) into the desired wall, leaving the head
extended out the by about 5mm.
2. Remove the stand from the Weather Station by pulling it away from the
base and hang the station onto the screw. Remember to ensure that it
locks into place before releasing.
Free standing
With the foldout stand, the weather station can be placed onto any flat surface.
POSITIONING THE TEMPERATURE SENSOR:
The Sensor is supplied with a holder that may be attached to a wall with the
two screws supplied. The Sensor can also be position on a flat surface by
securing the stand to the bottom to the Sensor.
Outdoor icon
Min icon
Min outdoor
temperature
Indoor
Temperature
Indoor Relative
Humidity %
Indoor icon
Outdoor
Temperature
Outdoor icon
Max icon
Max indoor
temperature
Indoor icon