Linn Akurate 225 - Manual (Page 17)

12
AKURATE Loudspeaker System
Owner’s Manual
AKURATE 221 English
PARAMETER SYMBOL 0 1 2 3 4 5 6 7 8 9
10 50 75 100 115 135 160 190 235
18 22 25 30 34 40
55 85 130
Description and available settings for parameters
Default settings are shown in grey.
* Only for use when the AKURATE 221 speaker is connected to a power amplifier
(see Connecting section in this chapter).
** If you are using the AKURATE 221 speaker with a Linn System Controller
or other AV processor, set to 4 (No filtering).
E Ex xtte errn na all h hiig gh h p pa as ss s
ffrre eq qu ue en nc cy y* *
Increasing the setting
reduces the bass
content sent to the
external speakers. (Hz)
IIn ntte errn na all h hiig gh h p pa as ss s
ffrre eq qu ue en nc cy y
Increasing the setting
raises the lowest
frequency produced
by the unit. (Hz)
IIn ntte errn na all llo ow w p pa as ss s
ffrre eq qu ue en nc cy y* ** *
Reducing the setting
lowers the highest
frequency produced by
the unit. (Hz)
NO FIL
TERING
PARAMETER SYMBOL 0 1 2 3 4 5 6 7 8 9
-15 -10 -5 0 +5 +10 +15
0 +1 +2 +3 +4
0 +3 +6
5 10 20
C Co oa arrs se e g ga aiin n
Every one step
increase in the setting
raises the gain (volume)
of the speaker by
5 decibels. Every one
step decrease in the
setting lowers the gain
(volume) of the
speaker by
5 decibels. (dB)
F Fiin ne e g ga aiin n
Every one step
increase in the setting
raises the gain
(volume) of the
loudspeaker by
1 decibel. (dB)
B Ba as ss s e eq qu ua alliis sa attiio on n
Every one step
increase in the setting
applies an additional
3 dBs at 30 Hz and
below. (dB@30 Hz)
T Tiim me e o ou utt
Length of time before
unit will go into
standby after audio
input ceases. (mins)
AL
W
A
Y
S
ON