Lathem ATX-GPS - Manual (Page 4)

Copyright © 2009 Lathem Time Corporation. All rights reserved.
Document number: USG0082
Mount the unit, according to the following steps.
•
Place the bracket at the selected location and mark the 2 mounting holes.
•
Drill a ¼” X 1 ½” hole at each of the marks
•
Insert the wall anchors in holes and tap flush to wall with a hammer.
•
Insert a screw through the top mounting hole and into the top anchor and
tighten securely.
•
Place the ATX-GPS Receiver on the top of the bracket.
•
Place the p-clip around the cable
•
Insert a screw through the p-clip, through the bottom mounting hole and
into the bottom anchor and tighten securely.
After mounting, connect the RJ45 jack to the RJ45 port of the ATX6. Verify the
Time Source (function 7) of the ATX6 is set to GPS.