Lionel Trains 73-0020-250 - Manual (Page 18)

Maintaining and servicing your set
1
linkage rods
front truck
screws
smoke unit
lug wire
smoke unit
lionel part no.
600-0161-300
Y
our locomotive lights the way with its operating headlight. During the course of normal
operations, the lamp may require replacement. Refer to Figure 12 as you replace the
lamp.
1. Remove the two front truck screws and carefully slide the front truck assembly off the link-
age rods.
2. Lift the smoke unit out far enough from the cab to allow lamp extraction.
3. Pull the lamp straight out and replace it with Lionel part no. 600-0161-300, available from
your nearest authorized Lionel Service Center or from Lionel Service. Be careful not to twist
the lamp, or it may break.
4. Reinstall the smoke unit, making sure that the smoke stack lines up with the cab top opening.
5. Reassemble the front truck, making sure that the linkage rods go into the holes in the
front truck. The lug wire from the smoke unit must be reinserted through the slot in the
front truck assembly and secured under one of the two front screws. Tighten the screws
firmly, but do not over-tighten them.
Replacing your locomotive’s headlamp
Figure 12. Headlight replacement