Lincoln FUSION TOASTER 2040 - Manual (Page 21)

Fusion Toaster Series Service Manual 21
TECHNICIAN MODE
The following information is for use by authorized service technicians only.
When in this mode, technicians will have the ability to set the following parameters:
TECHNICAL MENU ITEMS DESCRIPTION
Temperature Scale In Temperature Scale, the technician will have the ability to set temperature readings in either
°F or °C.
Sleep Mode Power Down % In this mode the technician can set the “Power Down Percentage” to meet the needs of the
end-user. For example, for greater energy savings the end-user may prefer that in Sleep
Mode the toaster operate at 20% of normal operating power output.
IMPORTANT: Please note that the greater the percentage difference between
normal operation and sleep mode, the longer the toaster will take to “power up” to
the programmed menu settings.
Exit Sleep Mode Time This menu allows the technician to set the length of time the red light will flash while toaster
exits sleep mode to enter into normal operation.
IMPORTANT: This time setting will not necessarily correlate to the toaster
achieving the normal operational menu setting. It is normal for the toaster to
require additional time to reach the normal operating menu settings after the red
light stops flashing. In some cases it may take an additional 10-15 minutes
depending on the difference between Sleep Mode Power Down Percentage and
normal operating settings.
Password Protection If the end-user would prefer the Technician Mode to be password protected to “lock out” the
Technician Mode from employees, the option of password protecting the settings is available.
The password can only be four (4) characters in length.
IMPORTANT: Treat this menu with caution! End user is responsible for
remembering their password.
IMPORTANT: Should the customer ever forget their password, the Fusion Toaster
is equipped with a “universal password” for use by the service technician. In the
event the customer cannot remember the password, simply insert the word “TECH”
into the display to access the Technician Mode. Note, the original password will
remain active until another password is selected.
1. Press the “Up-Scroll” AND “Down-Scroll” buttons at the same time for approximately 5 seconds. The menu
will flash “DEGF.” Press the “Up-Scroll” or “Down-Scroll” to change the setting between °F and °C.
!
!
!
!