LG WD-3243RHD - Manual (Page 7)

7
nstallation I
Water supply pressure must be between
4.5 ~ 145 PSI (30~1000 kPa)
Don’t strip or crossthread when connecting
Inlet hose to the valve.
If the water supply pressure is more than
1000 kPa, a pressure reducer device should
be installed.
• Two Sealing washer are supplied with the
water inlet hoses to prevent water leaks.
• Check water tightness of washing
machine connections by turning the tap
completely on.
• Periodically check the condition of the
hose and replace the hose if necessary.
• Make sure that there is no kink in the
hose and that it is not crushed.
• The Inlet hose which has red connector is
for the hot water tap.
Washing Machine is to be connected to the water mains using new hoses
Old hoses should not be used.
Connecting water supply hose
Sealing
washer
Hose connector
Hot water tap
Cold Hot
Cold
water
tap
1 . Do not use an extension cord or double adapter.
2 . If the supply cord is damaged, it must be replaced by the manufacturer or its service agents
or similarly qualified person in order to avoid a hazard.
3 . Always unplug the machine and turn off the water supply after use.
4 . Connect the machine to an earthed socket in accordance with current wiring regulations.
5 . The appliance must be positioned so that the plug is easily accessible.
Electrical connection