LG SAC30708043 - Manual (Page 94)

COMMER
CIAL
MODE
SETUP
92
LT2002 CLONING CONNECTIONS/LEARNING SETUP
COMMERCIAL MODE SETUP
Connections for the LT2002 Clone Programmer to Learn the TV Master TV Setup
Before you begin cloning...
■ The Master TV should be connected to a good, stable
signal from an over-the-air antenna or cable service
Analog channel and connected to power. (See above.)
■ Teaching and Learning is only possible between iden-
tical model devices. (However, the LT2002 Clone pro-
grammer can store up to 3 different ‘master’ setups.)
WARNING: Copying a blank or incorrect memory into
a TV, STB or other device will cause the TV, STB or
other device to operate erratically or become inopera-
ble.
■ Use an Installer’s remote to operate Learning and
Teaching menus.
■ Make sure that the batteries in the Clone programmer
are fresh.
■ If batteries are removed, the Clone Clock time will be
lost.
■ Decide if you want to set the time from the Clone
programmer or copy the time to the Clone program-
mer; from a compatible TV which has the clock set to
the current time.
■ Setting the time and transferring it to the Clone or
other device is a separate procedure.
■ Follow the connection diagram above to connect the
Clone to a Master TV TV display panel. After learning
is complete, to another identical TV TV display panel
to “teach” it the master setup.
■ See the Clone Troubleshooting section to resolve
problems.
Turn to the next page to continue Cloning Setup.
QuickSet II Programmer
LT2002
Ferrite Core
(TDK, ZCAT
2035-0930)
• heartbeat power on
communications ok
• slow power on
no communications
• green battery ok
• red
battery low
Blink pattern
Color Reset
Status
Indicator
Connect cable to
TV MPI Jack and
follow on screen
instructions
MPI
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
Antenna
or CATV
Master TV
Clone Programmer
G Do not use LT2002 while any PPV card is installed in TV or clone programmer device will be damaged.
Warning
NOTE !
G G It is assumed that the TV is connected to a signal source, the source selected is Antenna (RF) In, the signal
is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and
the LT2002 Clone Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on
the TV screen, see above and next page.