Lanzar Car Audio E540P - Manual (Page 19)

owner’s manual wiring
Connect 12V DC from a constant battery source to a +12V slip-on spade terminal
and install a one (1)amp fuse in line.
Connect the signal processor’s GROUND to a good chassis ground, near where
the unit is mounted, or to the case of the head unit.
Connect the signal processor’s REMOTE TURN-ON lead to the remote turn-
on lead out of the head unit, and install a 1/2 amp fuse in line. (A relay
should be used if turning on more than one component, such as EQ’s,
crossovers or amplifiers.)
Connect stereo RCA cables from the head’s left and right front outputs to
the left and right inputs of the signal processor.
Connect stereo RCA cables from the left and right outputs, (and low, mid
and high outputs if applicable), of the signal processor to the left and right
inputs of your amplifier(s)or additional signal processor(s).
Turn the unit on, and adjust the input gain on the signal processor to match
the output of the head unit (1/2, or at center position, is about 1 V). Be careful
not to overdrive the input of your amplifier(s)or signal processor(s). Use
clip detectors to adjust output.
Adjust each of the crossover or equalizer controls to achieve the desired
sound characteristics.
15
signal processors