Lightolier A0302 - Manual

IS IS IS IS:7084 :7084 :7084 :7084
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTALLATION PROCEDURE FOR ELLIPSOIDAL DOWNLIGHT (TUNGSTEN-HALOGEN)
CAUTION: (RISK OF FIRE) DO NOT INSTALL INSULATION ABOVE, NOR WITHIN 24 INCHES (610mm) OF ANY PART
OF THE LUMINAIRE.
INSTRUCTION SHEET NO.
A0302 Page 1 of 3
A COMPANY
631 Airport Road, Fall River, MA 02720
INSTALL WITH FOLLOWING MINIMUM SPACINGS BETWEEN
(A) CENTER-TO-CENTER OF ADJACENT LUMINAIRES: 48 INCHES (1219mm);
(B) TOP OF LUMINAIRE TO OVERHEAD BUILDING MEMBER: * INCHES ( * mm);
(C) LUMINAIRE CENTER TO SIDE BUILDING MEMBER: 24 INCHES (610mm).
*
FOR 7082, 6 INCHES (152mm)
*
FOR 7084, 3 INCHES (76mm)
A. INSTALL MOUNTING FRAME IN CEILING USING ADJUSTABLE
MOUNTING BRACKET
(1) With MOUNTING BARS (order separately):
18” – Cat. No. 1950; 27” – Cat. No 1951).
Use rectangular slots as shown.
(3) With 1 ½” channel (by others)
Slide MOUNTING BARS or CHANNELS (by others) through slots in ADJUSTABLE MOUNTING BRACKET which will place the
bottom of the MOUNTING FRAME approximately in line with the finished ceiling line. Final adjustments may be made by means of
MOUNTING BRACKET SCREWS on inside of fixture.
FIG. 1
FIG. 3 FIG. 2 FIG. 4
(2) With ¾” channel (by others)