Linn Akurate DS - Manual (Page 10)

AKURATE DS
Important:
The Akurate DS must be installed by an engineer/technician trained in
networks and network security. Linn Products Limited cannot be held
responsible for any network security compromise and/or loss of data due to
improper installation.
Unpacking
The Akurate DS is supplied with the following:
• handset
• 2 x AAA batteries for the handset
• 1 pair of black interconnect cables
• RS232 lead
• mains lead
• CD-ROM (contains system software, installation manual and
owner’s manual)
• warranty pack
We recommend that you retain all packaging in case you need to transport
the Akurate DS at a later date.
Positioning
You can position your Akurate DS almost anywhere you find convenient, but
please consider the following points:
• The unit should be placed on a flat, stable and rigid surface.
• Do not position the unit where sunlight can shine (whether directly,
diffused or reflected) on its display as the infra-red (IR) radiation in
sunlight will be picked up by the unit’s IR remote sensor and this can
adversely affect its operation. Similarly, some electrical devices such
as plasma TVs, fluorescent lights and energy saving lamps can emit IR
which can likewise affect the operation.
• For best performance do not stack the unit with other products. Ideally,
position the unit on a shelf by itself or, if proximity to other products is
unavoidable, positioning side-by-side is preferable to stacking.
INSTALLATION
• The unit should not be situated above, or directly adjacent to, sources of
heat such as radiators, power amplifiers etc. Nor should it be enclosed in
a cabinet with such devices.
• The unit itself produces very little heat; however it is advisable to allow a
little space to the sides, rear and above the unit (ideally 10 cm / 4”) for air
circulation which will allow any heat to dissipate.
Cleaning
Disconnect the Akurate DS from the power supply before cleaning. Remove
dust and fingerprints with a soft, dry cloth.
Connecting to the mains supply
The Akurate DS contains an automatic internal mains voltage switch. This
switch operates on all worldwide mains voltages from 100 V to 240 V. The unit
can be connected to any worldwide mains voltage with no adjustment.
This unit must be earthed. Use the earthed moulded mains lead
supplied, or if no mains earth is available, ensure the product’s
EARTH GROUND connector is connected to an earthing terminal.
2