Lancom Systems 821 - Manual (Page 24)

LANCOM 821 ADSL/ISDN – LANCOM 1621 ADSL/ISDN – LANCOM 1711 VPN
̈ Chapter 2: Installation
24
EN
The power LED flashes red/green in alternation until a configuration
password has been specified. Without a configuration password, the
configuration data of the LANCOM is insecure. Under normal circum-
stances, you would assign a configuration password during the basic
configuration (see instructions in the following chapter). For informa-
tion about a later assignment of the configuration password see the
section “Security settings” on page 66.
Online
·
The Online LED indicates the overall status of all WAN ports:
Flashing Power LED but no connection?
There's no need to worry if the Power LED blinks red and you can no
longer connect to the WAN. This simply indicates that a preset time or
connect-charge limit has been reached. There are three methods
available for unlocking:
̈
Reset connect charge protection.
̈ Increase the limit that has been reached.
̈
Completely deactivate the lock that has been triggered (set limit
to '0').
If a time or connect charge limit has been reached, you will be notified in LANmonitor. To
reset the connect charge protection, select Reset Charge and Time Limits in the context
menu (right mouse click). You can configure the connect charge settings in LANconfig under
Management / Costs (you will only be able to access this configuration if 'Complete con-
figuration display' is selected under View / Options…).
You will find the connect charge protection reset in WEBconfig and all parameters under
Expert Configuration / Setup / Charges- module.
Signal for reached time
or connect-charge
limit
Power Power
LANCOM
Systems
off No active connection
green flashing Establishing first connection
green inverse flashing Establishing further connection
green constantly on At least one connection established
red constantly on Error establishing the previous connection