Land Pride FDR2572 User Manual
Page 4
2
Important Safety Information
FDR2572 & FDR2584 and Rear Discharge Grooming Mowers 310-262M
5/29/13
These are common practices that may or may not be applicable to the products described in
this manual.
Use Safety
Lights and Devices
▲
Slow moving tractors, self-
propelled equipment, and towed
implements can create a hazard
when driven on public roads. They
are difficult to see, especially at
night.
▲
Flashing warning lights and turn
signals are recommended
whenever driving on public roads.
Tractors With Cabs
Tractors Equipped With
ROPS
▲
There should be sufficient
clearance for the operator when
equipment is hitched to a tractor
with a cab or ROPS.
▲
The ROPS may need to be
extended or flipped around to
obtain sufficient clearance.
Transport
Machinery Safely
▲
Comply with state and local laws.
▲
Maximum transport speed for
implement is 20 mph. DO NOT
EXCEED. Never travel at a speed
which does not allow adequate
control of steering and stopping.
Some rough terrain require a
slower speed.
▲
Sudden braking can cause a
towed load to swerve and upset.
Reduce speed if towed load is not
equipped with brakes.
▲
Use the following maximum
speed - tow load weight ratios as
a guideline:
20 mph when weight is less
than or equal to the weight of
tractor.
10 mph when weight is more
than weight of tractor but less
than double the weight of
tractor.
▲
IMPORTANT: Do not tow a load
that is more than double the
weight of tractor.
Practice Safe Maintenance
▲
Understand procedure before doing
work. Use proper tools and
equipment, refer to Operator’s
Manual for additional information.
▲
Work in a clean dry area.
▲
Lower the implement to the ground,
put tractor in park, turn off engine,
and remove key before performing
maintenance.
▲
Allow implement to cool.
▲
Do not grease or oil implement
while it is in operation.
▲
Inspect all parts. Make sure parts
are in good condition & installed
properly.
▲
Remove buildup of grease, oil, or
debris.
▲
Remove all tools and unused
parts from implement before
operation.