Land Pride FDR2572 - Manual (Page 15)

13
Section 2: Accessories & Set-up
FDR2572 & FDR2584 and Rear Discharge Grooming Mowers 310-262M
Table of Contents
5/29/13
Accessory Equipment
Front Roller
Refer to Figure 2-1:
1. Remove the front two 1/2"-13 x 1 1/2" GR5 hex
flange serrated screws (#9) and reinsert from the
bottom as shown. Secure with existing 1/2" whiz nuts
(#10). Tighten nuts to 76 ft-lbs of torque.
2. Assemble brackets (#2) and (#3) to deck with
carriage bolts (#4) and flange nuts (#5).
3. Insert roller (#8) between brackets and install pin
(#1) through brackets and roller. Secure with washer
(#6) and cotter pin (#7).
Front Roller Assembly
Figure 2-1
17713
Cutting Blades
There are four blade choices to select from based upon
soil condition, density of grass, and tractor horsepower.
The appearance of the finish cut may vary between low
lift and high lift blades. See your Land Pride dealer for
blade availability.
Low Lift Blades
Land Pride’s low lift blades are designed for mowing over
sandy soil terrain where high suction lift is not crucial.
Sand sucked into the blades accelerates blade wear
more than normal. Low lift blades are recommended
because they produce a lower suction keeping sand
uplift and blade wear to a minimum.
Medium Lift Blades (Factory Standard)
Land Pride’s medium lift blades are great when
horsepower is a concern. They produce a medium
suction to lift grass and require less horsepower than
high lift blades.
High Lift Blades
Land Pride’s high lift blades develop the greatest suction
for lifting grass before cutting for that fresh clean cut look.
However, they may require more horsepower especially
when cutting tall dense grass. They are not
recommended for sandy soil conditions.
Mulching Blades
Land Pride’s mulching blades are designed to chop
leaves and/or grass into smaller parts leaving your lawn
looking fresher and cleaner than ever before.
Accessory Part Numbers
See your Land Pride dealer for blade availability.
Land Pride Part Numbers & Descriptions
Part No. Part Description
Front Roller Assembly
310-254S FDR1648, FDR1660 & FDR1672
Low Lift Blade (3 blades required per mower)
890-200C FDR2572
890-685C FDR2584
Medium Lift Blade (3 blades required per mower)
890-318C FDR2572
890-675C FDR2584
High Lift Blade (3 blades required per mower)
890-172C FDR2572
890-684C FDR2584
Mulching Blade (3 blades required per mower)
890-698C FDR2572
890-706C FDR2584
Section 2: Accessories & Set-up