LG LRBP1031NI - Manual (Page 5)

ENGLISH
ESP
AÑOL
FRANÇAIS
5
Electrical Requirements
Before you move your refrigerator into its final
location, it is important to make sure you have
the proper electrical connection:
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused, grounded electrical supply is required. It
is recommended that a separate circuit serving
only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not
use an extension cord.
NOTE: Before performing any type of
installation, cleaning, or removing a light bulb,
turn the control, (Thermostat, Refrigerator, or
Freezer Control depending on the model) to
OFF and then disconnect the refrigerator from
the electrical source. When you are finished,
reconnect the refrigerator to the electrical
source and reset the control (Thermostat,
Refrigerator, or Freezer Control, depending on
the model) to the desired setting.
Registration
The model and serial number are found on the
rear of this unit. This number is unique to this
unit and not available to others. You should
record requested information here and retain
this guide as a permanent record of your
purchase. Staple your receipt here.
Date of Purchase :
Dealer Purchased From :
Dealer Address :
Dealer Phone No. :
Model No. :
Serial No. :
Electrical Shock Hazard
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
w w WARNING