Lantronix XPort AR - Manual (Page 62)

8: Configurable Pins Manager
XPort AR User Guide 62
2. Click a CP number (CP column) to display the status of that pin. The status is shown in the CP
Status section of the web page.
Table 8-2 lists and describes the fields for the selected CP.
Note: To modify a CP, all groups in which it is a member must be disabled. The changes
to a CP are not saved in FLASH.
Value Shows the current value of the CP.
Groups Indicates the number of groups in which the CP is a member.
Active In Group Shows the group in which the CP is active. A CP can be a member of several
groups. However, it may only be active in one group.
Table 8-2 CPM CPs Status Fields and Descriptions
Fields Description
Name Shows the CP number.
State Shows the current enable state of the CP. On the XPort AR the CP state is
always enabled.
Type Indicates whether the CP is set for input or output.
Value Shows the current value of the CP.
Bit Shows the bit position. CPs are always displayed in bit position zero.
Level Indicates the voltage level of the CP. A plus sign (+) indicates the CP is
asserted (the voltage is high). A minus sign (-) indicates the CP voltage is
low.
I/O Indicates the current status of the pin:
 I—Input
 O—Output
 <blank—Unassigned
Logic Indicates that the CP is inverted by displaying an "I".
Binary Shows the assertion value of the corresponding bit.
CP# Shows the CP number.
Groups Lists the groups in which the CP is a member.
Table 8-1 CPM CPs Current Configuration Fields and Descriptions (continued)
Field Description