LG DVT418 - Manual (Page 34)

34
Presetting the Radio Stations
You can preset 50 stations for FM and AM (MW).
Before tuning, make sure that you have turned down
the volume.
1. Press BAND on the remote control until FM or AM
(MW) appears in the display window.
2. And then every time you press BAND, FM and AM
(MW) changes alternately.
3. Press and hold TUNING or on
the front panel for about two seconds until the
frequency indication starts to change, then
release.
Scanning stops when the DVD/CD Receiver tunes in a
station. “TUNED” and “ST.” (for stereo program) appear
in the display window.
4. Press MEMORY/STOP on the front panel.
A preset number will flash in the display window.
5. Press TUNING or on the front
panel to select the preset number you want.
6. Press MEMORY/STOP on the front panel again.
The station is stored.
7. Repeat steps 3 to 6 to store other stations.
To tune in a station with a weak signal
Press TUNING or repeatedly in step
3 to tune in the station manually.
To clear all the stored stations
Press and hold MEMORY/STOP for about two
seconds and “CLEAR ALL” is appeared in the display
window and then press MEMORY/STOP again, the
stations are cleared.
If you have accidentally entered into the "CLEAR
ALL" mode and you do not wish to clear the
memory, do not press any key. After a few seconds,
the "CLEAR ALL" display will go off by itself and
change to normal mode.
Note:
If all stations have already been entered, the FULL
message will appear in the display window for a
moment and then a preset number will flash.
To change the preset number, follow the steps 5-6 as
above.
Listening to the Radio
Preset radio stations in the DVD/CD Receiver’s
memory first (see “Presetting radio stations” on the
left).
1. Press BAND until AM (MW) or FM appears in the
display window.
The last received station is tuned in.
2. Press PRESET +/- repeatedly on the remote
control to select the preset station you want.
Each time you press the button, the DVD/CD Receiver
tunes in one preset station at a time.
3. Adjust the volume by rotating VOLUME on the
front panel or by pressing VOLUME + or - on the
remote control repeatedly.
To turn off the radio
Press POWER to turn the DVD/CD receiver off or
select another function mode (CD/DVD, AV 1, etc.,).
To listen to non-preset radio stations
Use manual or automatic tuning in step 2.
For manual tuning, press TUNING or
on the front panel repeatedly.
For automatic tuning, press and hold TUNING
or for about two seconds on the
front panel.
To select a preset radio station directly
You can use the number buttons on the remote
control to select a preset radio station directly.
For example, to listen to preset station 4, press 4 on
the remote control. To listen to preset station 19,
press 1 then 9 (within 3 seconds).
For your reference
If an FM program is noisy
Press MONO/ST. on the front panel so that “ST.”
disappears in the display window. There will be no
stereo effect, but the reception will improve. Press
the button again to restore the stereo effect.
To improve reception
Reorient the supplied antennas.