Logan Graphic Products T300 - Manual (Page 3)

Operation
1. Raise cutting bar using lifter arm or raise to
full open position. (Fig. 6)
2. Slide material onto board and against squar-
ing arm. (Fig. 7)
3. Adjust Stop to desired dimension. (Fig. 8)
4. Lower Cutting Bar
5. Slide Cutting Head beyond end of material.
6. Pivot blade down fully until it locks. (Fig. 9)
7. Place hand on to cutting handle & pull cut-
ting head down through material until head
reaches support bar. (Fig 10)
8. Upon contact with support bar, the blade
holder will automatically release to safety
position. (Fig. 11)
Fig. 6
Fig. 9
Fig. 10
Fig. 11
Fig. 7
3
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 www.logangraphic.com
Total Trimmer Instruction Manual Model T300 &T360
Fig. 8