Lowrance electronic LVR-850 - Manual (Page 26)

20
Directory
The Directory is an organized list of (up to 10) MMSI numbers stored
on the DSC calling directory.
Storing/Editing MMSI Data
To store a new MMSI in an unused location, follow these steps:
1. Press the CALL key to display LAST . Use the
↑ ↓ keys to select
DIR .
The DIR ANNUNCIATOR
blinks.
2. Press the CALL key. The ID
ANNUNCIATOR
starts to blink ON/OFF , indi-
cating the directory EDIT MODE
is activated.
3. Use the
↑ ↓ keys to select an unused location. If the number location
is full, FL is displayed. If the location is available, CL appears on the
screen.
4. Select the CL location and press the MEM key to advance to the MMSI
input screen.
5. Press the
↑ ↓ keys to enter the MMSI digits. After entering the first
MMSI digit, press the MEM key to enter the second number. The big
digit, again starts at "0" and the small digit now displays “2” The small
number will increase each time you add a MMSI digit. Use the
↑ ↓ keys
to set the second MMSI digit and touch the MEM key to store. Repeat
the operation until all 9 digits have been entered and verified. After
entering the MMSI, review each digit by pressing the
MEM key. If there
is a mistake, press the 16/9 key to exit or just turn off the radio. The
MMSI will not be stored. After you are satisfied with your MMSI entry,
hold down the
CALL key for 5 seconds to store the number.
6. Press the 16/9 key to revert to the main screen.
DIR and ID
blink to
show Edit
mode
No. 3
is full
No. 4 is empty
and usable