LG LRSC21951ST - Manual (Page 24)

Care and maintenance
How to dismantle parts
Freezer
compartment
lamp
Dispenser lamp
Freezer
compartment
shelf
Door rack and
support
Ice storage bin
After dispenser
is used
Seperate the lamp by pulling it out, and then
remove the lamp. Max. 15 W bulb for
refrigerator is used and can be purchased at a
service center.
To remove a shelf, lift the left part of the shelf
a bit, push it to the direction ( ), lift the right
part to the diretion ( ), and take it out.
Lift the door rack holding both sides ( ) and
pull it out to ( ) direction.
The water collector has no self-drainage
function. So it should be cleaned regularly.
Remove the cover by pressing the left side of
water collector cover and dry it with a cloth.
Press the point marked as shown in the figure
to the right to remove the water collector
cover.
Hold the ice storage bin as shown in the right
figure and pull it out ( ) while slightly lifting it
( ).
It is recommended not to dismantle the ice
storage bin unless it is necessary.
Be sure to use both hands when removing
the ice storage bin, so as not to drop it on the
floor.
If the ice storage bin does not fit well, slightly
rotate the rotating device.
FRZTEMP
DISPENSER
REFTEMP SUPERFRZ
LOCK MIN MAX
MIN MAX
CUBED CRUSHED WATER
LOCK
ON OFF
ROOM TEMP
2750
2750
FRZ TEMP
DISPENSER REF TEMP
SUPER FRZ
LOCK
MIN MAX MIN MAX CUBE D CRUSHED WATER LOCK ON OFF ROOM
TEMP
FRZ TEMP
DISPENSER REF TEMP
SUPER FRZ
LOCK
MIN MAX MIN MAX CUBED CRU SHED WATER LO CK ON OFF ROO M TEMP
!
• Dismantling is done in the reverse sequence of assembly.
Be sure to unplug the power plug before dismantling and assembly.
Never apply severe force to dismantle parts. Parts may be damaged.
NOTE
24
Separate the lamp by pulling it out (➂) while
slightly striking (➀) and rotating (➁) the lamp
cover.
Turn the bulb counterclockwise. Max. 40 W
bulb for refrigerator is used and can be
purchased at a service center.