LG LRSC21935TT - Manual (Page 8)

8
Installation
Water connection instruction guide
Read all directions carefully before you begin. Connecting
the refrigerator
to a water source
Connect to potable water supply only. Warning
• If operating the refrigerator before installing the water connection, turn ice maker
to the OFF position to prevent operation without water.
• All installations must be in accordance with local plumbing code requirements.
• Use copper tubing and check for leaks.
• Install copper tubing only in areas where temperatures will remain above freezing.
• It may take up to 24 hours for your ice maker to begin producing ice.
IMPORTANT
The ice maker water valve contains a flow washer which is used as a water
pressure regulator.
The ice maker needs to be connected to a cold water line with water pressure
207 ~ 827 kPa (30 ~ 120 psi).
If a problem occurs, call your utility company.
Cold water supply
Standard screwdriver
7/16 - inch and 1/2 - inch open-end wrenches or two adjustable wrenches
1/4 - inch nut driver
1/4 - inch drill bit
Hand drill or electric drill (properly grounded) Tools required
• Your refrigerator dealer has a kit available with a 1/4 - inch saddle-type shut - off valve,
a union, and copper tubing. Before purchasing, make sure a saddle-type valve
complies with your local plumbing codes. Do not use a piercing-type or 3/16 - inch
saddle valve which reduces water flow and clogs more easily.
NOTE