La Crosse Technology WS-9043U - Manual (Page 7)

7
VIII. SETTING THE YEAR, DAY AND MONTH
Note: Reception of the WWVB signal will also set the date and day. The reception of the signal will override
any programmed date and day.
1. Press and hold the SET button for 3 seconds.
2. “LCD” will show in the TIME LCD and the number setting will flash.
3. Press and release the SET button seven times.
4. The year will flash in the DATE LCD.
5. Press and release the ALM/+ button to advance the year.
6. Press and release the SET button to confirm the year and advance to the
month setting.
7. The month will flash in the DATE LCD.
8. Press and release the ALM/+ button to advance the month.
9. Press and release the SET button to confirm the month and advance to the
day setting.
10. The day of the month will flash in the DATE LCD.
11. Press and release the ALM/+ button to advance the day of the month.
12. Press and release the SET button to confirm and advance to the snooze
setting.
IX. SETTING THE SNOOZE
1. Press and hold the SET button for 3 seconds.
2. “LCD” will show in the TIME LCD and the number setting will flash.
3. Press and release the SET button ten times.
4. “Sn” will appear in the DATE LCD and a number will be flashing next to it.
5. Press and release the ALM/+ button to select the duration of the snooze.
Note: The snooze can be set for 0 to 30 minutes in 5-minute increments. If 0 minutes is selected pressing the
WIND/SNZ button will deactivate the alarm and it will not come back on.
6. Press and release the SET button to confirm and advance to the forecast sensitivity setting.
X. SETTING THE FORECAST SENSITIVITY
Note: The forecast sensitivity can be adjusted to allow for areas that have a higher or lower sensitivity to
changing air pressure (for example coastal areas have more pressure change than areas such as southern
Arizona).
The numbers correspond to the amount of air pressure change necessary to trigger a change in the forecast icon.
Areas that tend to have more air pressure change would set the sensitivity to 3, while areas that experience lower
than normal air pressure change would set the sensitivity to 1.
1. Press and hold the SET button for 3 seconds.
2. “LCD” will show in the TIME LCD and the number setting will flash.
3. Press and release the SET button eleven times.
4. Either “1”, “2” or “3” will flash in the TIME LCD and the forecast icon and tendency arrows will flash in
the FORECAST LCD.
5. Press and release the ALM/+ button to select the forecast sensitivity.
6. Press and release the SET button to confirm the forecast sensitivity and complete the programming.