Lenoxx Electronics CT-99 - Manual (Page 11)

PRECAUTIONS
On Safety
•
Should any solid object or liquid fall
into the set, disconnect the power, and
have it checked by qualified personnel
before operating it any further.
On Power Sources
•
For battery operation, use 4 size “D”
batteries. We recommend alkaline
batteries for longer life.
•
When the batteries are not to be used,
remove them to avoid damage that can
be caused by battery leakage or
corrosion.
•
The nameplate indicating operating
voltage, power consumption, etc. is
located at the back of the set.
10
On Placement
•
Do not leave the set in a location
near heat source, or in a place subject
to direct sunlight, excessive dust or
mechanical shock.
•
Do not place the set on an inclined
or unstable place.
•
Do not place anything within 1 inch of
the back of the cabinet. The ventilation
holes must be unobstructed for the
set to operate properly and prolong
the life of its components.
•
If the set is left in a car parked in
the sun, be sure to choose a location
in the car where the set will not be
subjected to the direct rays of the sun.
•
Since a strong magnet is used for the
speakers, keep personal credit cards
using magnetic coding or spring-
wound watches away from the set
to prevent possible damage from the
magnet.
Notes on Cassettes
•
Break off the cassette tab from side A
or B to prevent accidental recording.
If you want to reuse the tape for
recording, cover the broken tab with
adhesive tape.
•
To record on a tape with its tab broken
off, cover the respective tab hole for side
A or B with adhesive tape.
•
The use of a cassette with more than 90
minutes of play time is not recommended
except for long continuous recording or
playback.
•
To reduce the chances of tape jamming
or tangling, you should check that there
are no loose layers of tape visible
through the cassette center window. If
any, tighten these loose layers of tape
using a pencil before inserting the
cassette into the set.
Side A
Tab for side A
Tab for side B