Lowrance electronic LMS-520C - Manual (Page 239)

229
Highlight
C
ALIBRATE
T
RIM
and press
ENT
. The Device Calibration window
will appear with a list of Calibration Instructions.
4. Highlight
S
TART
C
ALIBRATION
and press
ENT
. The following message
will appear: Please fully raise the Engine Trim.
5. After engine trim has been fully raised, press
ENT
. The following
message will appear: Please fully lower the Engine trim.
6. After engine trim has been fully lowered, press
ENT
. A Calibration
Completed message will appear. Press
ENT
.
7. Repeat these instructions to adjust the engine trim for each engine
connected to a Suzuki Engine Interface. Press
EXIT
repeatedly to return
to the main display.
Reset Trim Calibration
If you are not satisfied with your engine trim calibration, you can reset
engine trim calibration from the Suzuki Engine Interface Advanced
Options menu.
1. Press
MENU
|
MENU
, select
NMEA 2000
and press
ENT
.
2. Choose
B
US
S
ETUP
and press
ENT
. Select the Suzuki Engine Interface
connected to the desired engine and press
ENT
.
3. Highlight
A
DVANCED
O
PTIONS
and press
ENT
. Select Reset
T
RIM
C
ALIBRA-
TION
and press
ENT
. The following message will appear: Do you wish to
re-calibrate the device?
4. Highlight
Y
ES
and press
ENT
. Press
EXIT
repeatedly to get back to the
main display.
Bennett Trim Tabs Calibration
Trim Tabs will be calibrated through their Device Configuration menu.
To calibrate Trim Tabs:
1. Press
MENU
|
MENU
, select
B
US
S
ETUP
and press
ENT
. A list of network
devices will appear.
2. Select
B
ENNETT
T
RIM
T
ABS
from the list and press
ENT
, which will open
the Trim Tab Device Configuration menu.
3. Highlight
C
ALIBRATE
and press
ENT
. The Device Calibration window
will appear with a list of calibration instructions.
4. Select
S
TART
C
ALIBRATION
and press
ENT
. The following message will
appear: Please fully raise Trim Tabs.
5. After fully raising the trims tabs, press
ENT
. The following message
will appear: Please fully lower trim tabs.
6. After fully lowering the trim tabs, press
ENT
. A Calibration Complete
message will appear. Press
ENT
. Press
EXIT
repeatedly to return to the
main display.