Land Pride SA35 - Manual (Page 12)

10
Section 1: Assembly & Set-up
6/12/13 Model SA35 Hydraulic Post Hole Digger 317-093M
Table of Contents
Unhooking Post Hole Digger
Refer to Figure 1-1 & Figure 1-6 on page 9:
1. Rotate top of tilt arms back and lower Skid Steer/
Tractor lift arms down until the auger tip touches the
ground.
2. At this point, slowly back Skid Steer/Tractor up until
hitch plate frame is on the ground.
3. Stop engine, engage parking brake, raise seat bar,
move controls until both are locked and remove key
to prevent unauthorized starting. Use steps,
grab-handles and skid-resistant surfaces when
getting on or off the loader.
4. Disconnect hydraulic hoses and release locking
levers or pins. It may be necessary to release
hydraulic pressure in the lines before hoses will
disconnect from the loader.
5. Restart Skid Steer/Tractor and slowly rotate tilt arms
back and lower loader arms down until auger tip and
auger hitch plate are both resting on the ground.
6. Continue to lower the loader arms until the Skid
Steer/Tractor hitch clears the auger hitch plate top
angle bar.
7. Back away from auger hitch plate and then raise Skid
Steer/Tractor loader arms up.