Lowrance electronic 5200C - Manual (Page 133)

127
set the backlight level to 75 percent on one display unit, all other units
on the network will automatically switch to the same setting.
To turn on/off Backlight Synchronization:
1. Press
MENU
|
MENU
, select
NMEA 2000
and press
ENT
.
2. Highlight
B
ACKLIGHT
S
YNCHRONIZATION
and press
ENT
, which will turn
on/off Backlight Synchronization.
3. Press
EXIT
repeatedly to get back to the main display.
Configuring EP Sensors
All configurable devices are configured through their Device Configura-
tion menus, which may be accessed through the network devices list on
the Bus Configuration menu.
EP-35 Temperature Configuration
To input Device Name:
1. Press
MENU
|
MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the temp sensor you want to rename and press
ENT
. The De-
vice Configuration menu will appear with the Device Name dialog box
highlighted.
4. Press
ENT
and use ↑ ↓, ← → to input the desired name for the temp
sensor. Press
ENT
. Press
EXIT
repeatedly to get back to the main dis-
play.
To select Temp Type:
1. Press
MENU
|
MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press
ENT
. The Device Configura-
tion menu will appear.
4. Highlight
T
EMP
T
YPE
and press
ENT
. The following list of Temp Types
will appear: Water, Outside, Inside, Engine Room, Cabin, Live Well,
Bait Well, Refigeration, Heating System and Unknown.