LSI MiniHAB 44929LO - Manual (Page 43)

2 Gbit/s Fibre Channel to PCI Host Adapters 3-1
Ver. 2.0 Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Chapter 3
Firmware Installation
Procedure
This chapter provides information about installing and configuring Fibre
Channel firmware and includes these topics:
•
Section 3.1, “Introduction,” page 3-1
•
Section 3.2, “FC Firmware,” page 3-1
•
Section 3.3, “Installing the Firmware,” page 3-3
•
Section 3.4, “Configuring the Firmware,” page 3-4
•
Section 3.5, “Troubleshooting,” page 3-7
3.1 Introduction
The LSI Logic Fibre Channel chips and host adapters contain firmware
that presents a multi-protocol service layer based on the LSI Logic
Fusion-MPT architecture. The Fibre Channel firmware provides FCP
(SCSI-3 over Fibre Channel) Initiator, FCP Target, and LAN interface
services to the host system.
The FC929.ROM file contains the firmware that supports the LSIFC929 or
LSIFC919 chips and all associated host adapters.
3.2 FC Firmware
This section includes the features, description, installation, and
configuration of the FC firmware.