LG 26LH1DC1 - Manual (Page 55)

COMMERCIAL MODE
COMMER
CIAL MODE
55
INSTALLER OVERVIEW
Operating Installer Menu
To set up the controls for the TV you will need to know how to enter the
26LH1DC1 Installer menu and make changes to the default values as
required. If necessary, familiarize yourself with the 26LH1DC1 Installer
menu and how to make and save changes in the menu.
Optional Installer Remote
You will need an Installer remote control similar to the one shown to the
right.
The TV’s closable features need to be set up before 2-5-5 + Menu is
done.
This is a critical step.
If the Master TV display panel’s closable features like: Clock Set, adding
channel icons and channel labels, etc. are not done properly, then the
cloned 26LH1DC1 TVs will all have problems. For example, do not do
2-5-5 + Menu more than once or the TV setup will become corrupted.
If you need to start the procedure over, then begin by setting installer
item 117 to 001, and pressing Enter to reset the TV to default values in
the installer menu. You can do 2-5-4 + Menu mode more than once but
this mode is limited to only editing channel icons and channel labels.
Refer to the appropriate section in the Manual for other TV features:
Picture, Sound etc.
LT2002 Clone Programmer
As the cloning procedure is being performed, specific steps need to be
done at the indicated times to achieve the desired
result. Be sure to do each cloning task as indicated.
If a procedure or step is left out or not performed
correctly, then the TV setup will be wrong and
cloning may network. At each step, pay attention to
assure the TV screen shows the proper message(s)
when cloning. If the message indicated does not
appear, there is a problem with that step and cloning
may not be successful. Cloning is only possible when
the signal source is an Analog channel, not a digital
channel.
Following is the Commercial Mode Operation Setup.
QuickSet II Programmer
LT2002
¤
HOSPITAL PTC INSTALLER MENU
000 INSTALLER SEQ 000
UPN 000-000-000-000 FPGA 09F1
PTC V1.00.000 CPU V1.01.00
Typical Installer Menu