Listen Technologies LT- 800-072 - Manual (Page 12)

8
Setup Instructions Setup InstructionsQuick Reference
Speci
fi cations
Package Contents Package Contents Setup Instructions
LT-800 Setup Instructions (cont.)
To Select Phonak Mode:
Press and hold down the channel select “up” button while
powering on the unit. The LCD will display a “P” momentarily
upon power up indicating that the transmitter is in the Phonak
Channel Mode. The channels displayed will now match
Phonak channels. To return to the Listen channel designations,
repeat this process. The LCD will display an “L” momentarily
upon power up indicating that you are in the Listen
Channel Mode.
Select Channel Mode (if necessary)
Your transmitter has been shipped to you with only a limited number of channels available (Basic
Mode). If all channels (Expanded Mode) are required, use the following procedure.
6
To Select Expanded Mode:
To enable or disable the Expanded Mode, press and hold the
channel select “down” button while powering on the unit. When
the Basic Mode is enabled, “L/O” (lockout) will be displayed on the
LCD display as shown below. This indicator is extinguished when in
the Expanded Mode.
Set SQ™ (Super Quiet) and Process Features
Your transmitter is shipped to you with SQ (super quiet) enabled and Process disabled. For
a detailed description of these features and when to use them, please refer to page 12.
7
To Disable or Enable SQ and Process Features:
With the unit on press and hold the channel select “Down” button for 8 seconds. The
program (PGM) icon will appear on the LCD.
Once in the program mode,
the SQ and Process featurs can be turned on and off by pressing the channel select
buttons. Press the channel select “Up” button to toggle between Process On and Off.
Press the channel select “Down” button to toggle between SQ On and Off.
If the green LED is displayed on the front panel,
that feature is enabled. Once you have enabled or
disabled the features as desired, let the transmitter
exit the program mode by waiting 5 seconds.
Program
icon
LED lit when
SQ is enabled
LED lit when
Process is enabled