Operation, Loading pellets, The two modes of operation – Lopi Masonry Fireplace Factory Built (Metal) Fireplace Mobile Home Model: Pioneer Bay (Heritage Bay PI) User Manual

Page 17: Auto (requires a thermostat), Switching modes while in operation

Advertising
background image

Operation

1 5

Travis Industries

4 0 5 1 2 1 6

9 3 5 0 8 0 5 1

Loading Pellets

Lift the hopper lid to its vertical position. Pour pellets into the hopper until full. NOTE: The hopper
holds approximately 35 pounds of pellets.

The front edge
of the hopper

lid becomes
very hot, do not

touch the area
below the

handle.

WARNING:

Make sure
pellets are not

left on this
heat shield.

Pe

t

e

l

s

l

NOTE: press the spring here
while closing the hopper lid.

Close the lid slowly to prevent
pinching your finger.

The Two Modes of Operation:

M a n u a l

Manual mode requires the user to turn
the heater on and off manually.

Auto (requires a thermostat)

Auto mode allows you to use a
thermostat to control room
temperature. The stove automatically
turns on when the temperature drops
below the thermostat setting. Once the
stove reaches operating temperature,
the stove then runs at the heat output
setting selected.

Switching Modes While in
Operation

Whenever the stove is switched from
one mode to another while in
operation, the stove will enter the "start-
up" sequence for a minimum of 20
minutes.

HIGH

DISCONNECT POWER BEFORE SERVICE

REMOTE

AUTO

MANUAL

H
E
A
T

O
U
T
P
U
T

MED

LOW

AUGER

FAULT

AUTO

OFF

MANUAL

H
E
A
T

F
A
N

UP

DOWN

UP

DOWN

MANUAL

MANUAL

START

AUGER

TRAVIS INDUSTRIES

HOUSE OF FIRE

TM

Use the mode

switch to

determine the

mode.

These indicator lights

are used to determine

which mode you are in.

NOTE: if using a

modulating remote, this

light will come on to

indicate the remote is

controlling the heater.

Advertising