Lenoxx Electronics IB-PH5595 - Manual (Page 10)

IB-PH5595-WM-E-032704
BASICS
Making and Receiving Calls
MAKING A CALL
1. Pick up the handset to get a dial tone. The hook icon will show in the display..
2. Dial the phone number. The dialed number appears in the display.
3. When you finished talking, replace the handset into the base.
RECEIVING A CALL
1. Pick up the handset when the phone rings. The hook icon will show in the display..
2. After a few seconds, the display will show the Count Up Call Timer.
3. When you finished talking, replace the handset into the base.
8
Your phone will now go to the Time and Date mode, press the UP or DOWN button to get to
the correct number and the MENU button to accept.
You do not have to set up the Time and Date because the telephone company will auto-
matically update this with your Caller ID when your phone rings (twice or more).
(Example: 10:53 a.m. On June 18th)
Step 4: Setting up the Telephone (Continued)
GETTING STARTED
Then the display will ask you to select the type of dialing (TONE or PULSE) that you desire
or that your telephone system requires. Press DOWN or UP button to select TONE or
PULSE mode.
TONE - The set will operate using tone dialing.
PULSE - The set will dial using rotary dial type pulses (clicking sounds).
If you are not sure of your dialing system, make a trial call in TONE mode. If the call
connects, leave the mode as it is; otherwise, set it to PULSE.
Even when your phone is set to pulse service, this phone can be switched to temporary
tone for access to services that require tone signaling including Telephone Banking. Just
press the TONE
button after dialing in pulse and your buttons can now be used for
tone signaling for this call only.
Press the DELETE button to get back to the standby mode (for dialing) and the normal
display shows (see below for example):
NOTE: To use caller ID service, you will probably need TONE dialing.
IB-PH5595-WM-E-032704.P65 4/8/2004, 3:17 PM 10