Power wiring, Specifications ordering information, Mounting – Liebert Network Device EIA-485/232 User Manual

Page 2: Caution

Advertising
background image

2

© 2005 Liebert Corporation
All rights reserved throughout the world. Specifications subject
to change without notice.

® Liebert is a registered trademark of Liebert Corporation. All
names referred to are trademarks or registered trademarks of
their respective owners.

SL-28110_REV01_09-08

Liebert Corporation

1050 Dearborn Drive
P.O. Box 29186
Columbus, OH 43229

Telephone: 1-800-877-9222
Facsimile: 1-614-841-6022
www.liebert.com

Power Wiring

Mounting

Screw the Liebert SiteTPI-1 into an enclosed panel using the mounting holes provided on the cover plate. Be

sure to leave about 2" (50mm) on each side for wiring.

Specifications

Ordering Information

!

CAUTION

The Liebert SiteTPI-1 is a Class 2 device (less than 30VAC, 100VA maximum). Take

appropriate isolation measures when mounting the Liebert SiteTPI-1 in a control panel where

non-Class 2 devices (for example, 120VAC) or wiring are present.

Power

24VAC ±15%, 50-60Hz, 20VA power consumption (single Class 2 source only,

100VA or less)

Dimensions, W x D x H: in. (mm)

4.1 x 1-1/2 x 5.2 (104.14 x 38.1 x 132.08)

Memory

1 MB Flash, 2 MB RAM

Communication

Ports

One 2-wire EIA-485 port
One jumper-configurable EIA-232/EIA-485 (2-wire/4-wire) port
One Rnet port (EIA- 485, 115.2k bps) for communication with a BACview, RS

sensors, or WebCTRL

Baud rates

(protocol dependent)

BACnet MS/TP = 9600, 19.2k, 38.4k, and 76.8k
Modbus = 9600, 19.2k, and 38.4k
Rnet = 115.2k

Environmental

Operating Range

-22° to 150°F (-30-65.5°C); 10 to 95% relative humidity, noncondensing.
For UUKL Smoke Control Systems, 32°F-120.2°F (0°C-49°C); 10-85% relative

humidity, non-condensing

Protection

Built-in surge and transient protection circuitry

Battery

Lithium 3V coin cell battery, CR2032, provides a minimum of 10,000 hours of data

retention during power failures

Fault Detection

Hardware watchdog timer

Memory

1MB Flash memory and 1MB non-volatile battery-backed RAM (does not lose

information that was stored before a power failure)

Regulatory Compliance

Listed

FCC Part 15 - Subpart B - Class A

Pending at Publication

UL 916 (PAZX), cUL C22.2 No. 205-M1983 (PAZX7), CE (1997)

Quantity

Part #

Description

SiteTPI-1

One-to-One Third-Party Interface Module

Advertising