LifeSource UT-101 User Manual
Page 9
LifeSource Health Line (Toll-Free): 1-888-726-9966
8
HOW TO TAKE A TEMPERATURE READING
1.
Install the probe cover on the probe.
(A probe cover was installed at time of purchase.)
Mate the probe cover groove with the protrusions on the
thermometer.
2.
Press the START button. The display indicates all the
symbols, the previous reading, and finally “00.0ºC ” with
the READY mark on. Now the thermometer is ready to
measure temperature.
NOTE: Do not keep pressing the START button. Press and
release it immediately
.
3.
Insert the thermometer gently into the ear. Always insert the
thermometer into the same ear with the same direction and
depth. (See “HOW TO INSERT THE THERMOMETER
INTO THE EAR” on page 7.)
After seconds, you hear the beep sound that tells you the
end of measurement. Gently remove the thermometer from
the ear. Read the measurement on the LCD panel. At this
time, the READY mark is flashing.
4.
After about ten seconds, the READY mark turns off.
To measure again, press the START button once. You may
take a second reading immediately.