Land Pride FDR3590 - Manual (Page 13)

11
Section 1: Assembly and Set-up
12/10/07 FDR3590 Rear Discharge Grooming Mowers 310-229M
Land Pride
Table of Contents
Accessory Equipment
Anti-Scalping Front Roller
Refer to Figure 1-6:
1. Insert 4 x 10 roller wheel (#5) and spacer tubes (#4)
between mounting bracket flanges as shown.
2. Install front roller shaft (#2) through the bracket
flanges, spacers and roller.
3. Secure roller shaft with 3/8”-16 x 1” GR5 hex head
cap screw (#1) and lock nut (#3). Tighten lock nut to
proper torque. See Torque Values Chart on page 25.
Front Roller Assembly
Figure 1-6
16570
Cutting Blades
There are four blade choices to select from based upon
soil condition, density of grass, and tractor horsepower.
The appearance of the finish cut may vary between low
lift and high lift blades. See your Land Pride dealer for
blade availability.
Low Lift Blades
Land Pride’s low lift blades are designed for mowing over
sandy soil terrain where high suction lift is not crucial.
Sand sucked into the blades accelerates blade wear
more than normal. Low lift blades are recommended
because they produce a lower suction keeping sand
uplift and blade wear to a minimum.
Medium Lift Blades
Land Pride’s medium lift blades are great when
horsepower is a concern. They produce a medium
suction for lifting grass requiring less horsepower than
high lift blades. Medium Lift Blades are factory furnished
with your mower.
High Lift Blades
Land Pride’s high lift blades develop the greatest suction
for lifting grass before cutting for that fresh clean cut look.
However, they may require more horsepower especially
when cutting tall dense grass. They are not
recommended for sandy soil conditions.
Mulching Blades
Land Pride’s mulching blades are designed to chop
leaves and/or grass into smaller parts leaving your lawn
looking fresher and cleaner than ever before.
Accessory Part Numbers
See your Land Pride dealer for blade availability.
Land Pride All-Flex Mower Accessories
Part No. Part Description
Front Roller
310-233A FDR3590 Front Roller
Low Lift Blades (3 blades needed)
890-205A Mower Blade 5/16 x 31 17/32 SD LL CW
Medium Lift Blades (3 blades needed)
890-533C Mower Blade 5/16 x 31 17/32 SD ML CW
High Lift Blades (3 blades needed)
890-223C Mower Blade 5/16 x 31 17/32 SD HL CW
Mulching Blades (3 blades needed)
890-704C Mower Blade 1/46 x 31 17/32 SD CW