Line 6 Looper JM4 - Manual (Page 9)

SD Card Details
2•1
Format Card
It’s best to start out with a new 1 GB or 2 GB SD card. If you have an existing card, that’ll
work also, but make sure you’ve backed up all the data on the card first, because once you
do a format, your card will be completely erased. The main reason to format your SD card
is to ensure your card is set up with the JM4 filing system. It’s also a good way to get a fresh
start in organizing your sessions. To format your SD card, follow these steps:
Insert an SD card (up to 2 GB) into the SD card slot on the JM4 rear panel. •
Press the • SAVE button; you’ll see a list of menu items in the LCD.
Turn the wheel and navigate to • Format Card, then press the R Arrow to format.
Press the Up Arrow to confirm “ • Yes”. The format process will take a few seconds.
When the format process is complete, press any button to begin a new session. •
As you begin recording with your JM4, before you know it you’ll find you’ve accumulated
quite a few recordings. Since internal memory is limited, you’ll want to develop a good
system for backing them up, for beginning new sessions with a clean slate, and for importing
WAV files from your computer. With that in mind, here are 3 good rules to go by:
Use an SD card as your primary memory bank to keep internal memory freed up. •
Back up every session of internal memory recordings to SD card. •
For maximum recording time, begin every new session with JM4 memory cleared. •
sd C
ard
d
etails
In this chapter we’ll focus on the SD card. With an SD card inserted into your JM4’s SD
card slot, you can save and load your original recordings, perform mixdowns in WAV file
format, import WAV files from your computer, and upgrade your JM4 firmware.
All the SD card-specific menu items described in this chapter are accessed by pressing the
SAVE button. The first thing you’ll want to do is format your SD card.
FIRMWARE VERSION
IMPORT WAV FILE FROM CARD
FORMAT CARD FORMAT CARD