Test that clock is now set correctly, 9 close and lock the unit – Lathem 2121 User Manual
Page 11
Advertising
Model 2121 Time Recorder User’s Guide
Page 9
8. Test that Clock Is Now Set Correctly
8.1 When the clock advances to the next minute, you hear a
distinct click.
8.2 Insert a card or piece of paper below the print ribbon.
8.3 Push lever on front of the unit down to make a print.
8.4 Verify that the clock face time matches the printed time.
If it does not, start again with
Lift the Type Section
.
Otherwise, continue to step 9.
9 Close and Lock the Unit
9.1 Slide the case cover on the unit.
9.2 Turn the key to lock the unit and remove the key.
Note: This completes the setup of this unit. The following
procedures contain service instructions.
Advertising