Lowrance electronic LDT-3003 - Manual (Page 4)

4
The temperature sensors can be mounted in any convenient location.
Use #8 stainless steel screws to attach the sensor to the hull. (Screws not
included.) When mounting the water temperature sensor as shown above,
make certain to place it on the transom where it will be in contact with the
water at all times, if possible.
OPERATION
Modes
The LDT-3003 has a clock,a clock alarm, up to three temperature dis-
plays, an alarm for each temperature sensor, an engine hour meter, and a
voltmeter. To switch between these modes, simply press the mode key.
Clock
When the unit is turned on, the clock appears as
shown at right. A dot in the upper left corner of the
screen is for a.m. or p.m. - it's your choice when
you set the clock. The clock will continue to run
even when the unit is turned off.
Water Temperature
The first temperature to appear after pressing the
MODE key is the water temperature. This sensor
is mounted on the transom.
T2 Temperature
The second temperature to appear is T2. This sen-
sor can be mounted in a live well, on the hull to
measure outside air temperature, or just about any
other location.
MODE
MODE