Lopi Freedom Fireplace Insert - Manual (Page 32)

32 Optional Equipment
© Travis Industries 100-01162 4041105
Surround Panels
SURROUND PANEL SIZE HEIGHT WIDTH PART #
8" 29-1/2" 45-3/8 " 99300293
10" 31-1/2" 49-3/8 " 99300294
12" 33-1/2" 53-3/8 " 99300295
Installation Instructions
1. With the insert 12” from the
fireplace, install the side
surround panels (see the
directions to the right).
2. Adjust the position of the
side panels so they are: 1)
flush with the bottom of the
insert; 2) both the same
distance back from the
front of the insert; 3)
perpendicular to the floor
(use the top panel, if
necessary, to judge
alignment). Tighten the
screws that hold the side
panels in place.
3. Place the insert into the
fireplace and connect the
flue. Install the top panel
and trim following the
directions to the right.
Convection
Channel
3/8" Nutdriver
Attach the side panels
using the included
screws & nuts.
NOTE:
The inner flange on the
panel fits into the
convection channel.
"L" Bracket
Right Side
Trim
Top Trim
Optional Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Micro (1/16”)
Standard
Screwdriver
Install the top panel so the tabs insert
into the joggle clips on the top panel
Top
Panel
Spring
Clips
Optional Knock-Out
An optional knock-out is provided on both
sides if the power cord is routed behind the
surround panel.