Lowrance electronic 6 - Manual (Page 30)

24
J. After the MapCreate files have been installed on your computer, you
are prompted to install the MMC card reader drivers. Make sure the
card reader is not plugged in yet, then click O
K
to continue. (If you stop
the program, you can install the card reader later, but MapCreate will
not run until the card reader is installed. To install later refer to the
instruction sheet that came with the card reader.)
K. The setup program for the USB SD/MMC Reader loads.
L. When the setup program has loaded, a welcome screen is displayed.
Click the N EXT button when you're ready to begin the card reader in-
stallation.