Lanzar Car Audio SD34MIP - Manual (Page 6)

08
39
Before You Start
6
Replacing the Fuse
Make sure the amperage matches the
specified value when replacing the fu-
ses. If the fuse is blown, check the po-
wer connection and replace with a n-
ew one. If the same problem occurs,
it would be subjected to the malfun-
ction. In such cases, please consult
to the nearest service dealer.
When the range of the operation of the
card remote control becomes short or no
functions while operating. Replace the
lithium battery with a new button cell
(CR2025). Make sure the battery polarity
before replace.
Precautions on Using Lithium
Battery
Always keep the lithium battery beyond
children s reach. In case
swallowed, see a doctor immediately.
Cleaning the battery with a dry cloth,
to ensure its perfect connected.
Make sure the proper polarity when
loading with the battery.
To prevent short circuit, do not use
metal tweezer to clip the battery.
Gently pull out the Battery Holder while
pressing the Stopper.
Put the button-type battery with mark(+)
upward into the Battery Holder.
Replacing the Battery
Insert the Battery Holder into the Remote
Control.
!
Maintenance
Warning
Never use the fuse with the rated
amperage more than that supplied to
your unit, otherwise it will damage the
unit.
!
Tuner
Warning
Improperhandle with the batter may
lead to explosion.
It cannot be charged, disassembled
or thrown into a fire.
* This function is only operated by using rem-
ote control.
Scanning/Memorizing Stations
Automatically
During radio status, you can press AMS
button on the remote control to scan each
stored station 5 seconds respectively which
stored in Number Buttons (from 1 to 6).
You can press the corresponding Number
Buttons or AMS button when your desired
station is charged. And it starts playing that
station.
When press and hold
AMS ,
automatically memory storing fun-
ction. The radio automatically selects a
station and has it stored in any one of the
Number Buttons from 1 to 6.
button it will
activate
4
24
Notes:
Number Buttons
During radio mode, Number Buttons
from 1 to 6 can help you store your
favorite station. You can follow the
as below: steps
You can store up to 18 FM stations 6 each
for FM1,FM2,FM3),up to 12AM stations
(6 each for AM1/MW and AM2/LW). (
24
When receiving a station, press and hold
any one of the Number Buttons until
CH i
(i=1~6) appears on the LCD, which in-
dicates that station is already stored in the
corresponding number button.
Note:
Press AMS on the head unit also performs
the same function.
The unit can be stored up to 6 stations for
each band.
Regarding the function of Number Buttons,
refer to Number Buttons for more inform-
ation.
*
*
*
4
Selecting Station Directly
Press GOTO button, the monitor shows:
FR:, input the number to receive the station
of this frequencies.
Note:
2
* This function is only operated by using rem-
ote control.