Section 2: set-up of options, Blade offset cylinder, Table of contents blade offset cylinder – Land Pride Rear Blades RBT4096 User Manual

Page 12

Advertising
background image

10

Section 2: Set-Up of Options

RBT4084, RBT4096 & RBT40108 Rear Blades 301-206M

6/12/13

Table of Contents

Blade Offset Cylinder

Refer to Figure 2-1:

1.

Position hydraulic cylinder (#3) with ports on top as
shown. Select two 90 degree elbows (#4) and install
them into the cylinder ports as shown. Tighten as
needed.

IMPORTANT: Do not remove shipping block from
blade tilt housing until after All cylinders, manual
links, and/or ratchet jack have been installed.

IMPORTANT: Attach cylinder base to the front
mounting lug. The cylinder base will interfere with
mainframe if attached to blade pivot mounting lug.

2.

Screw 78" long hydraulic hose (#6) onto elbow (#4)
at the cylinder base and tighten.

3.

Screw 87" long hydraulic hose (#5) into elbow (#4)
located at the cylinder rod end and tighten.

4.

Thread adapter fittings (#7) to the other end of the
hydraulic hoses and tighten. (Hydraulic couplings
are furnished by others.)

5.

Attach hydraulic cylinder to the lugs located on the
left side of the Rear Blade with clevis pins (#1). Make
sure hydraulic ports are positioned on top and the
cylinder base in positioned to the front as shown.

6.

Secure clevis pins with hair pin cotters (#2).

7.

Route hoses through hose bracket located on the
right side of the front hitch. Connect hoses to
tractor's hydraulic system.

Hydraulic Blade Offsetting, Angling and Tilt

Figure 2-1

25532

SHIPPING BLOCK

DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.

Section 2: Set-Up of Options

Advertising
This manual is related to the following products: