Land Pride Rear Blades RBT4096 - Manual (Page 13)

11
Section 2: Set-Up of Options
RBT4084, RBT4096 & RBT40108 Rear Blades 301-206M 6/12/13
Table of Contents
Blade Angling Cylinder
Refer to Figure 2-2:
1. Position hydraulic cylinder (#3) with ports on top as
shown. Select two 90 degree elbows (#4) and install
them into the cylinder ports as shown. Tighten as
needed.
IMPORTANT: Do not remove shipping block from
blade tilt housing until after ALL cylinders, manual
links, and/or ratchet jack have been installed.
IMPORTANT: Attach cylinder base to the front
mounting lug. The cylinder base will interfere with
mainframe if attached to blade pivot mounting lug.
2. Screw 78" long hydraulic hose (#6) onto elbow (#4)
at the cylinder base and tighten.
3. Screw 87" long hydraulic hose (#5) onto elbow (#4)
at the cylinder rod end and tighten.
4. Thread adapter fittings (#7) to the other end of the
hydraulic hoses and tighten. (Hydraulic couplings
are furnished by others.)
5. Attach hydraulic cylinder to the lugs on the right side
of the frame with clevis pins (#1). Make sure
hydraulic ports are positioned on top and the cylinder
base in positioned to the front as shown.
6. Secure clevis pins with hair pin cotters (#2).
7. Route hoses through hose bracket located on the
right side of the front hitch. Connect hoses to
tractor's hydraulic system.
Blade Angling Hydraulic Cylinder Assembly
Figure 2-2
25533
SHIPPING BLOCK
DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.