Land Pride Rear Blades RBT4096 - Manual (Page 14)

12
Section 2: Set-Up of Options
RBT4084, RBT4096 & RBT40108 Rear Blades 301-206M 6/12/13
Table of Contents
Blade Tilting Cylinder
Refer to Figure 2-3:
1. Position hydraulic cylinder (#3) with ports on top as
shown. Place orifice (#4) in the port hole at the rod
end of cylinder. B
2. Select two 90 degree elbows (#5) and install them
into the cylinder ports as shown. Tighten as needed.
IMPORTANT: Do not remove shipping block from
blade tilt housing until after ALL cylinders, manual
links, and/or ratchet jack have been installed.
IMPORTANT: Attach cylinder base to upper
mounting lug. The base will interfere with moldboard
if attached to the lower moldboard mounting lug.
3. Screw 129" long hydraulic hoses (#6) into the
elbows (#5) and tighten.
4. Thread adapter fittings (#7) to the other end of the
hydraulic hoses and tighten. (Hydraulic couplings
are furnished by others.)
5. Attach hydraulic cylinder (#3) to the lugs at the back
of the blade with clevis pins (#1). Make sure
hydraulic ports are positioned on the back and the
cylinder base is mounted to the center lug as shown.
6. Secure clevis pins with hair pin cotters (#2).
7. Route hoses through hose brackets located on the
main frame and hitch. Connect hoses to tractor's
hydraulic system.
8. Remove shipping block at this time.
Blade Tilting Hydraulic Cylinder Assembly
Figure 2-3
25534
SHIPPING BLOCK
DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.