Linksys BEFSX41 - Manual (Page 8)

Chapter 2
Advanced Configuration
5 Broadband Firewall Router with 4-Port Switch/VPN Endpoint
desired. You should leave this value in the 1200 to 1500
range. Most DSL users should use the default of 1492.
When you are finished, click the Save Settings button.
Then click the Status tab, and click the Connect button to
start the connection.
Heart Beat Signal
Heart Beat Signal is a service used in Australia only. If you
are using a Heart Beat Signal connection, check with your
ISP for the necessary setup information.
Internet Connection Type > Heart Beat Signal
User Name and Password Enter the User Name and
Password provided by your ISP.
Heart Beat Server Enter the IP address of your ISP’s Heart
Beat server. This is provided by your ISP.
Connect on Demand: Max Idle Time You can configure
the Router to cut the Internet connection after it has been
inactive for a specified period of time (Max Idle Time). If
your Internet connection has been terminated due to
inactivity, Connect on Demand enables the Router to
automatically re-establish your connection as soon as you
attempt to access the Internet again. To use this option,
select Connect on Demand. In the Max Idle Time field,
enter the number of minutes you want to have elapsed
before your Internet connection terminates. The default
Max Idle Time is 5 minutes.
Keep Alive: Redial Period If you select this option, the
Router will periodically check your Internet connection. If
you are disconnected, then the Router will automatically
re-establish your connection. To use this option, select
Keep Alive. In the Redial Period field, you specify how often
you want the Router to check the Internet connection. The
default value is 30 seconds.
Host Name/Domain Name Enter a Host Name and
Domain Name if required by your ISP.
MTU The MTU option specifies the largest packet size
permitted for network transmission. Select Enable if
you do not want the Router to regulate this packet size
(otherwise, leave it set at Disable) and enter the value
desired. You should leave this value in the 1200 to 1500
range. Most DSL users should use the default of 1492.
When you are finished, click the Save Settings button.
Then click the Status tab, and click the Connect button to
start the connection.
L2TP
L2TP is a service that applies to connections in Israel only.
Internet Connection Type > L2TP
Server IP Address Enter the IP address of the L2TP server.
This is provided by your ISP.
User Name and Password Enter the User Name and
Password provided by your ISP.
Connect on Demand: Max Idle Time You can configure
the Router to cut the Internet connection after it has been
inactive for a specified period of time (Max Idle Time). If
your Internet connection has been terminated due to
inactivity, Connect on Demand enables the Router to
automatically re-establish your connection as soon as you
attempt to access the Internet again. To use this option,
select Connect on Demand. In the Max Idle Time field,
enter the number of minutes you want to have elapsed
before your Internet connection terminates. The default
Max Idle Time is 5 minutes.
Keep Alive: Redial Period If you select this option,
the Router will periodically check your Internet
connection. If you are disconnected, then the Router
will automatically re-establish your connection. To use
this option, select Keep Alive. In the Redial Period field,
you specify how often you want the Router to check
the Internet connection. The default Redial Period is
30 seconds.
Host Name/Domain Name Enter a Host Name and
Domain Name if required by your ISP.
MTU The MTU option specifies the largest packet size
permitted for network transmission. Select Enable if
you do not want the Router to regulate this packet size
(otherwise, leave it set at Disable) and enter the value
desired. You should leave this value in the 1200 to 1500
range. Most DSL users should use the default of 1492.
When you are finished, click the Save Settings button.
Then click the Status tab, and click the Connect button to
start the connection.