Attaching child safety seats with tether straps, Seating and safety restraints – Lincoln 2009 Navigator User Manual

Page 628

Advertising
background image

WARNING: Never attach two child safety seats to the same
anchor. In a crash, one anchor may not be strong enough to hold

two child safety seat attachments and may break, causing serious
injury or death.

If you install a child seat with rigid LATCH attachments, and have
attached the top tether strap to the proper top tether anchor, do not
tighten the tether strap enough to lift the child seat off the vehicle seat
cushion when the child is seated in it. Keep the tether strap just snug
without lifting the front of the child seat. Keeping the child seat just
touching the vehicle seat gives the best protection in a severe crash.

Each time you use the safety seat, check that the seat is properly
attached to the lower anchors and tether anchor, if applicable. Tug the
child seat from side to side and forward and back where it is secured to
the vehicle. The seat should move less than one inch when you do this
for a proper installation.

If the safety seat is not anchored properly, the risk of a child being
injured in a crash greatly increases.

Combining safety belt and LATCH lower anchors for attaching
child safety seats

When used in combination, either the safety belt or the LATCH lower
anchors may be attached first, provided a proper installation is achieved.
Attach the tether strap afterward, if included with the child seat. Refer
to Recommendations for attaching child safety restraints for children
in this chapter.

Attaching child safety seats with tether straps

Many forward-facing child safety seats include a tether strap which
extends from the back of the child safety seat and hooks to an anchoring
point called the top tether anchor. Tether straps are available as an
accessory for many older safety seats. Contact the manufacturer of your
child seat for information about ordering a tether strap, or to obtain a
longer tether strap if the tether strap on your safety seat does not reach
the appropriate top tether anchor in the vehicle.

Some of the rear seats of your vehicle are equipped with built-in tether
strap anchors located behind the seats as described below.

In the third row center seating position, the tether anchor is a loop at
the bottom of the seatback.

2009 Navigator (nav)
Owners Guide, 2nd Printing
USA
(fus)

Seating and Safety Restraints

204

Advertising