LeapFrog Nitro 4-Tec 3.3TM all-wheel-drive 4809 - Manual (Page 15)

Nitro 4-Tec 3.3 • 15
The Traxxas TQ Radio System
Remember, always turn the
TQ transmitter on first and
off last to avoid damage to
your Nitro 4-Tec. Never turn
the radio off while the
engine is running.
TQ Radio System Rules
Each time you prepare to run your Nitro 4-Tec,
you must clear your frequency to be sure no
one else in the area is using the same channel
as you.
There are six possible channels, numbered 1
through 6. Each is represented by a color. Look
at the crystal plugged into the back of your
transmitter to determine which channel your
car is assigned to.
Always turn your TQ transmitter on first and off last. This procedure
will help to prevent your Nitro 4-Tec from receiving stray signals from
another transmitter, or other source, and running out of control.
Always have the transmitter and receiver turned on before you start
the engine. Never turn the radio system off while the engine is
running. The on/off switch in the model only turns the receiver on
and off. It does not turn off the engine.
Always use new or freshly charged batteries for the radio system.
Weak batteries will limit the range of the radio signal between the
receiver and the transmitter. Loss of the radio signal can cause you to
lose control of your Nitro 4-Tec.
Channel 1
Brown
Channel 2
Red
Channel 3
Orange
Channel 4
Yellow
Channel 5
Green
Channel 6
Blue
CH.2
CH.1
Always turn your transmitter on first. Always turn your receiver on second. Then start your engine.
1 2 3